Search results

Anybody?

Thats pretty much exactly how I do it👌

Does anybody have or have any leads to a pair of rotors for these old Sram hubs.?

I do love a pre 1990 bike😎

I've got a couple.

They do that, it's called internal combustion, bloody marvelous invention

.... I should add... I'll be replacing the Odyssey triple traps before my shins end up at A&E. And.... Miraculously the fork holds air and goes up and down as it should😲 I am tempted to flip the stem for the full xc look🤔😂

It's been quite sometime since I've ventured into the Retrobike forums. But I always keep an eye out for a bargain, so when this popped up locally for less the cost of a Smoke rear I couldn't resist. It wants front wheel bearings and ill probably upgrade the tatty Deore octalink crank for an xt...

As above please. 1997 one would be good but anything considered. Ta

Ive got a good friend in Australia who I am sure would order some and send them on.

Well it's not that one! The more I look at it the more I'm convinced it's left hand thread!!!

Never found anything else more comfy and it's perfect for my short 'straight out the front door local loop' which is flat ish.

100/135. Adaptors off the interweb and a couple of small washer type spacers to get them in and discs on correct alignment then redish the wheels to centralise the rims. It only happened as i saw the wheels advertised really cheap and I like a challenge😁

I live in hope😁

I decided to take a punt on the type b Dura ace one of that era. Dims say its the right length and diametre. Assume it's the correct/same thread. Will report back on the off chance that it fits😁

Been using this quite a bit recently. Picked up a lovely pair of Mavic Elite XA 27.5 Boost wheels for it surprisingly cheaply. Bit of tweakage and they are in, front runs a smidge off centre. Lighter than the old tubeless wheels even with tubes in as i didnt have any sealant left. Anybody...

Following intently😁 Just picked a set up for buttons, but no bolt☹️

Did these go?

The list the parts, and the prices are surprisingly reasonable, but all out of stock. 😢

I'm building my old Blur up for winter use. Theres a lot of play in the bottom pivot on the suspension linkage. Bearings are good, the play is partly due to the bush being worn and partly, I suspect, that the linkage is worn. Are spares for these available anywhere? Ta