Adapters to convert a Hope Bulb front hub from QR to 20mm

[Bullpup]

I am looking for adapters to convert a Hope Bulb front hub from QR to 20mm bolt-through.

Does anyone have a set please?

Many thanks

 

[Timoth27]

Re:

I don’t have any spare unfortunately but just be careful there are different lengths, you want:

Bulb Splined
13.5mm/13.5mm
Bulb 6 bolt
19mm/13.5mm

 

[Bullpup]

Re: Re:

I don’t have any spare unfortunately but just be careful there are different lengths, you want:

Bulb Splined
13.5mm/13.5mm
Bulb 6 bolt
19mm/13.5mm

Thank you very much - I wasn't aware of that.

 

[Timoth27]

Re:

No problem I only found out myself when I was trying to swap a bigun to bulb. There are actually 6 different lengths depending on what hub you have. (Sorry if I’m telling you how to suck eggs) in case you don’t realise the bulb qr axle actually unscrews to take it apart, it’s not end caps like the modern stuff. You put a hex key in each end.

 

[Bullpup]

Re: Re:

No problem I only found out myself when I was trying to swap a bigun to bulb. There are actually 6 different lengths depending on what hub you have. (Sorry if I’m telling you how to suck eggs) in case you don’t realise the bulb qr axle actually unscrews to take it apart, it’s not end caps like the modern stuff. You put a hex key in each end.

Thanks again - I had better check what I actually need!

 

[Timoth27]

Re:

No problem, just pop up a pic if your not sure someone will know what you need.

 

[killingtime88]

Re:

I have spacers for hope bulb hub for 20mm thru axle and am looking for a 9mm quick release axle.
Ive done a quick measure and one spacer is 13.75mm long one is 19.25mm long, both 20mm bore, large outside diameter 30mm where they contact the sealed bearings.I also have the retaining circlips.
The hub they came from is the 6 bolt disc type.
The wheel was fitted with these spacers into a downhill bike so i presume they are correct.
Colour is black btw if that matters
Regards Paul