Inspired by benandemu's mount vision I have begun (what I can only assume will be the long task of) stripping down my 2000 Wolf Ridge. I may have secured a fox float to replace the old vanilla and then I was hoping to get it stripped and polished thinking of going for the original style marin logo (fluro yellow) and maybe either mat powder coating or anodizing the swing arm (any help on these would be appreciated and if I go with fluro decals do I go for black or gray swing arm?) I have however I have run into two problems, so advice would be appreciated:
1) The main pivot is stuck in the frame bolts are out but the bit running through the frame wont budge.
2) Don't want to hand my frame over to any old tom dick or harry to media blast so does anyone know anyone good around the Winchester area? Or would I be best to just go with the nitromors/autosol/elbow grease route?
Original(ish) but sorry state
The offending pivot axel
1) The main pivot is stuck in the frame bolts are out but the bit running through the frame wont budge.
2) Don't want to hand my frame over to any old tom dick or harry to media blast so does anyone know anyone good around the Winchester area? Or would I be best to just go with the nitromors/autosol/elbow grease route?
Original(ish) but sorry state
The offending pivot axel